Suppressor FAQs

Warranty
This warranty applies only when the suppressor is used under normal, intended conditions with compatible firearms and over restricted barrel lengths, proper mounting systems, and ammunition that meets SAAMI and/or NATO specifications.
We will repair or replace (at our discretion) any suppressor found to have a verifiable manufacturing defect — at no cost to you (excluding shipping and any required ATF transfer taxes/fees).
What Is Covered (Examples of Manufacturing Defects)
•Material flaws, poor welds, or out-of-spec tolerances present at the time of manufacture •Failures directly caused by a manufacturing defect (e.g., weld separation, bafflemisalignment due to machining error)
What Is NOT Covered
This warranty does not cover:
•Normal wear and tear (including baffle/core erosion, end-cap erosion, or any degradationfrom round count or heat)
•Any damage caused by misalignment, improper mounting, ammunition issues, or user error
•Use of Dead Air KeyMo (or compatible KeyMo-style) mounting systems — due todocumented high failure rates leading to misalignment and catastrophic damage, KeyMomounts are explicitly excluded
•Any attempt to disassemble, modify, alter, or perform unauthorized repairs (oursuppressors are permanently welded and not designed for user disassembly)
•Use of improper, reloaded/hand-loaded, remanufactured, substandard, or out-of-specification ammunition
•Improper installation, misalignment, or failure to verify clear bore/mount alignment beforefiring
•Use on incompatible hosts, over-bore pressure issues, or barrel/obstruction-related strikes
•Lack of maintenance, neglect, abuse, misuse, or criminal activity
•Normal cosmetic wear (scratches, dings, cerakote/finish chips, or fading)
•Damage from aggressive cleaning agents/solvents that strip finish or coatings
•Improper cleaning methods (e.g., abrasive tools, wire brushes, or anything inserted into thebore)
•Rust, corrosion, or environmental damage
Recommended Cleaning & Maintenance (To Preserve Warranty)
Our sealed suppressors require minimal maintenance but can be safely cleaned via non-invasive methods:
• Ultrasonic cleaning (fully assembled and sealed) is approved and recommended
• Dip/soak methods in non-corrosive solutions (e.g., CLR, vinegar mixes, or suppressor-specific cleaners) following industry best practices
• Never attempt to separate the tube from end caps or baffle stack — doing so will void the warranty
Paint and Finish
Cosmetic finish (Cerakote, Nitride, Anodizing, etc.) is not covered after the product leaves our facility and is used.
Non-Warranty Repairs
Even if damage is not covered under warranty (e.g., wear, user error, excluded mounts, etc.), Breek Arms will attempt to repair or re-core your suppressor:
• You will receive a quote for parts + labor (customer approves before work begins)
• Total repair cost will not exceed 50% of current MSRP for a comparable new unit
• Discounted replacement options may be offered when repair is not practical
Warranty Claim & Repair Process
1. DO NOT ship your suppressor without prior authorization — this is an NFA item and unauthorized shipment may violate federal law.
2. Contact timgrover@rev-tac.com with: – Serial number – Proof of original purchase – Detailed description/photos of the issue – Host firearm details, mount used, round count, and ammo type
